Quantcast
Channel: IT Certification Success Guaranteed, The Easy Way!
Viewing all articles
Browse latest Browse all 36

[2017-11-NEW] Download Latest Cisco 300-101 Dumps ROUTE PDF Exam Certification Format of Questions And Answers Video Online

$
0
0

Where can one get notes for Cisco 300-101 dumps exam?”Implementing Cisco IP Routing” is the name of Cisco 300-101 exam dumps which covers all the knowledge points of the real Cisco exam. Download latest Cisco 300-101 dumps ROUTE pdf exam certification format of questions and answers video online. Pass4itsure Cisco 300-101 dumps exam questions answers are updated (119 Q&As) are verified by experts.

The associated certifications of 300-101 dumps is CCDP.  Additionally, these Cisco 300-101 exam questions & present e-mail address facts are created by the https://www.pass4itsure.com/300-101.html dumps professionals who have created it big in the Information Technological advancement market.

Exam Code: 300-101
Exam Name: Implementing Cisco IP Routing
Q&As: 484

[2017-11-NEW Cisco 300-101 Dumps From Google Drive]: https://drive.google.com/open?id=0BwxjZr-ZDwwWWDdYaFM0SVFwMTA

[2017-11-NEW Cisco 100-105 Dumps From Google Drive]: https://drive.google.com/open?id=0BwxjZr-ZDwwWeVQ5WUxjZG1Idnc

300-101 dumps
QUESTION 1
Refer to the exhibit.
300-101 dumps
Based on this FIB table, which statement is correct?
A. There is no default gateway.
B. The IP address of the router on FastEthernet is 209.168.201.1.
C. The gateway of last resort is 192.168.201.1.
D. The router will listen for all multicast traffic.
300-101 exam 
Correct Answer: C
Explanation
Explanation/Reference:
Explanation:
The 0.0.0.0/0 route is the default route and is listed as the first CEF entry. Here we see the next hop for this default route lists 192.168.201.1 as the default router (gateway of last resort).
QUESTION 2
Refer to the exhibit
300-101 dumps
A network administrator checks this adjacency table on a router. What is a possible cause for the incomplete marking?
A. incomplete ARP information
B. incorrect ACL
C. dynamic routing protocol failure
D. serial link congestion
Correct Answer: A
Explanation
Explanation/Reference:
Explanation:
To display information about the Cisco Express Forwarding adjacency table or the hardware Layer 3-switching adjacency table, use the show adjacency command.
Reasons for Incomplete Adjacencies
There are two known reasons for an incomplete adjacency:
The router cannot use ARP successfully for the next-hop interface.
After a clear ip arp or a clear adjacency command, the router marks the adjacency as incomplete. Then it fails to clear the entry. In an MPLS environment, IP CEF should be enabeled for Label Switching. Interface level command ip route-cache cef
No ARP Entry When CEF cannot locate a valid adjacency for a destination prefix, it punts the packets to the CPU for ARP resolution and, in turn, for completion of the adjacency.
QUESTION 3
A network engineer notices that transmission rates of senders of TCP traffic sharply increase and decrease simultaneously during periods of congestion. Which condition causes this?
A. global synchronization
B. tail drop
C. random early detection
D. queue management algorithm
300-101 dumps 
Correct Answer: A
Explanation
Explanation/Reference:
Explanation:
TCP global synchronization in computer networks can happen to TCP/IP flows during periods of congestion because each sender will reduce their transmission rate at the same time when packet loss occurs. Routers on the Internet normally have packet queues, to allow them to hold packets when the network is busy, rather than discarding them. Because routers have limited resources, the size of these queues is also limited. The simplest technique to limit queue size is known as tail drop. The queue is allowed to fill to its maximum size, and then any new packets are simply discarded, until there is space in the queue again. This causes problems when used on TCP/IP routers handling multiple TCP streams, especially when bursty traffic is present. While the network is stable, the queue is constantly full, and there are no problems except that the full queue results in high latency. However, the introduction of a sudden burst of traffic may cause large numbers of established, steady streams to lose packets simultaneously.
QUESTION 4
Which three problems result from application mixing of UDP and TCP streams within a network with no QoS? (Choose three.)
A. starvation
B. jitter
C. latency
D. windowing
E. lower throughput
Correct Answer: ACE
Explanation
Explanation/Reference:
Explanation:
It is a general best practice not to mix TCP-based traffic with UDP-based traffic (especially streaming video) within a single service provider class due to the behaviors of these protocols during periods of congestion. Specifically, TCP transmitters will throttle-back flows when drops have been detected. Although some 
UDP applications have application-level windowing, flow control, and retransmission capabilities, most UDP transmitters are completely oblivious to drops and thus never lower transmission rates due to dropping. When TCP flows are combined with UDP flows in a single service provider class and the class experiences congestion, then TCP flows will continually lower their rates, potentially giving up their bandwidth to drop-oblivious UDP flows. This effect is called TCP-starvation/ UDP-dominance. This can increase latency and lower the overall throughput. TCP-starvation/UDP-dominance likely occurs if (TCP-based) mission-critical data is assigned to the same service provider class as (UDP-based) streaming video and the class experiences sustained congestion. Even if WRED is enabled on the service provider class, the same behavior would be observed, as WRED (for the most part) only affects TCP-based flows. Granted, it is not always possible to separate TCP-based flows from UDP-based flows, but it is beneficial to be aware of this behavior when making such application-mixing decisions.
QUESTION 5 
Which method allows IPv4 and IPv6 to work together without requiring both to be used for a single connection during the migration process?
A. dual-stack method
B. 6to4 tunneling
C. GRE tunneling
D. NAT-PT
300-101 pdf 
Correct Answer: A
Explanation
Explanation/Reference:
Explanation:
Dual stack means that devices are able to run IPv4 and IPv6 in parallel. It allows hosts to simultaneously reach IPv4 and IPv6 content, so it offers a very flexible coexistence strategy. For sessions that support IPv6, IPv6 is used on a dual stack endpoint. If both endpoints support IPv4 only, then IPv4 is used.
Benefits:
Native dual stack does not require any tunneling mechanisms on internal networks Both IPv4 and IPv6 run independent of each other Dual stack supports gradual migration of endpoints, networks, and applications.

300-101 dumps

Pass4itsure 300-101 dumps study material contains the format of question and answers. It is in conformity with the actual exam situation and therefore will be equal to your https://www.pass4itsure.com/300-101.html dumps exam specifications.

Read More Youtube:https://youtu.be/Kzd25sHJz1A

The post [2017-11-NEW] Download Latest Cisco 300-101 Dumps ROUTE PDF Exam Certification Format of Questions And Answers Video Online appeared first on IT Certification Success Guaranteed, The Easy Way!.


Viewing all articles
Browse latest Browse all 36

Trending Articles